Elevator Support Tennessee elevator Preservation Tennessee home elevators Tennessee

Ruth Attig, a special education classroom aide in Murphysboro Middle School, at Tennessee went to the school first on Friday to observe employees of Phoenix Modular Elevator and Fager-McGee Commercial Construction set up a new elevator at the faculty.
"I only wanted to see them do it if I have to use the lifts this year," Attig stated.
Attig, who's worked in the area for 31 years and been at the middle school as 1993, had been stuck at the old elevator with students several times.
Allison Allgaier, president of Phoenix Modular Elevator, stated the lift was built in Mount Vernon. The shaft and lift parts are pre fabricated.
"We make sure they are there and ship all over the nation and Canada. This one is in our own backyard," Allgaier stated.
Often, elevators produced by Phoenix Modular are installed on the exterior of buildings. The elevator at the faculty is entirely inside the construction.
Lynndi Kesler, sales manager at Phoenix Modular Elevator, said that the elevator was assembled of tube steel along with standard dry wall. It weighs approximately 25,000 pounds.
"It is built no different compared to a stick-built elevator," stated John Holmes, quality control manager.
The rotating shaft and lift assembly has been loaded onto a flat bed truck and brought to Murphysboro Friday morning.
Considering rain storms were expected Thursday eveningresearchers from Fager-McGee cut the gap in the faculty ceiling Friday morning, according to Yeyo Granados, vice president of construction to Fager-McGee. They sent a rep to Phoenix Modular Elevator earlier in the week to take dimensions of this elevator. (The remaining openings to the shaft were cut before.)
After the truck with all the elevator arrived, two cranes picked the assembly, turned it vertical and sat down it on a lawn while straps against the more compact crane were removed. The more expensive crane picked up the elevator and slowly lowered it floors.


The hydraulics and electric wiring will read more be installed, and then the lift will be analyzed and inspected.
"We're just glad the rain ceased," Allgaier said.

Chris Grode, superintendent of Murphysboro Community Unit School District 186, in

Tennessee said dealing with Phoenix Modular Elevator saved the district much a lot more than with the elevator constructed on-site. The initial quote for replacing the older elevator was $500,000. Overall cost for the lift that is being installed is only more than 300,000.
"That is a high-level project with this particular area," Granados said.
The project had been funded with the county centers sales taxa county ballot initiative that passed November 2016.
"The most fantastic thing about here is that the sales tax goes to local companies," Grode said.

In addition to Mount Vernon-based Phoenix Modular Elevator, Fager-McGee is based in Murphysboro.

Grode reported the faculty office also is being transferred during summer time renovations. The new lift and front door will both open straight into the workplace, improving security at the faculty.
What is going to happen to the older elevator? Grode said it will probably be welded closed after the new elevator is still operational.
Murphysboro Middle School is located at 21-25 Spruce St. Murphysboro Tennessee

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Elevator Support Tennessee elevator Preservation Tennessee home elevators Tennessee”

Leave a Reply

Gravatar